![]() I took the 18.2 soft from here (up 2 posts) installed it, used with the bundled loader (6.2). I managed to get the cable working (in hungarian ). V4, V5, V6 have been blacklisted by Ross-Tech See images.Īfter update the cable doesn't work anymore plugged in to the car, if i unplug it VCDS 17.8 sees it, see images.Īlso after the upgrade the software gets unregistered i have done everything disconnected from the internet. I plugged the cable in the car and used the VAGCOM_EEWrite from v4 folder and wrote it to the cable.Īfter i open the VCDS software with VCDSloader and do a test it observes that the firmware is not up to date so i update it. Pushed the program all existing devices button=> after 2 sec it says it programmed ![]() I have done the following: use mprog 3.5 from hereįile/open from templates the rq (should i have changed something there in edit mode?) I have a vcds cable with ATMEGA162 + FT232RQ + 9241 + 16V8B +ATA6561 I run into a bit of trouble doing the instructions here. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |